Dewalt table saw blade8/17/2023 ![]() If this is a new saw, I'd carefully degrease the entire spindle and blade hardware because it might still be covered in a factory anti-rust coating. Make sure the entire spindle and all the spacers and washers are free of sawdust and other debris. Make sure there is no oil or grease on the nut or the arbour.This is how most saws like to be treated: (Though, they usually discuss blade size in terms of the the riving knife installed rather than mass.) ![]() ![]() The model described here doesn't seem to have a brake, but I suppose a valid check is to make sure the blade or blade stack isn't exceeding their recommendations. Once powered down and free-spinning the mass of the blade is now free to loosen the arbor nut, which is why dado sets and saws with brakes may tend to loosen the arbor. Well, it is the rotation into the material that tends to tighten the arbor nut. So you just have to make sure it is torqued down appropriately. Once the arbour nut is tight, the rotation of the spindle will tend to tighten it.
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |